Design: The PERFECT Mag-Lev VAWT ( Vertical Axis Wind Turbine ) This design lets you build the Perfect VAWT from cheap parts, which should be capable of generating ONE HELL OF A LOT OF POWER. Since it’s a Mag-Lev it’s nearly frictionless, so efficiency can’t possibly get any better than this. You’ll need : 3 Plywood round plates, 3 Ft. diameter by 0.5 inch thick with 2 inch hole in center 32 Neodynium disk magnets, N45 ( shown in red/blue in video, red is north pole ) 4 Neodynium Torus magnets, N45 ( shown in red/blue in video, red is north pole ) 32 small plastic spools of Copper wire, 14 Gauge solid with enamel insulation ( for coil ) 1 Steel pipe, 4 Feet long at 2 inch thick, with mountable support legs ( maybe auto part ? ) 16 plastic plates, 1 Foot by 3 Foot by 0.5 inch thick 64 small right-angle mounts 128 wood screws, 0.5 inches long phillips 1 metal lock-ring torus, 2 inch diameter hole in middle with screw in from side to fix to axle Once you have these items, watch the video to see how it goes together………..SIMPLE !!!!! Venger Ps- WARNING: Magnets can crush fingers if not careful, so apply them one at a time. Glue them to lower side of Rotor plate, and encase them in liquid plastic, let harden……..